For over 30 years the leading pallet and sawmill magazine in America.
Gateway Fabricating Introduces Its New Raptor 3000 Trim Saw - 2/6/2017
Gateway Fabricating is a new company to the pallet industry but not new to providing useful business products. It is introducing a new trim saw, the Raptor 300. Gateway’s projects range from access and work platforms to large pipe bridges and entire industrial buildings. Its clients include some of the major industrial firms and contractors in the St. Louis area. Its experience includes bridges, refineries, petrochemical plants, mining facilities, power plants, elevated storage tanks, ground storage tanks and waste/water facilities.
Add the pallet industry to Gateway Fabricating’s impressive list of varied customers. It says that its Raptor 3000 trim saw is the next generation of trim saws. It was designed by someone with years of experience in the pallet industry and is constructed in the USA. According to Gateway, the key features of the Raptor 3000 are its precise measurements, speed, safety, and efficiency. See a video of it in operation at www.GatewayFabricating.com.
The Raptor 3000, made in the USA, uses circular blades that run at 1700 rpm with five hp saw motors and a two hp motor chain drive. It has adjustable locking arms, adjustable speed chain drive, adjustable heights, and two emergency start/stop buttons. The Raptor 3000 occupies approximately a 7 ft. x 5 ft. space. It will cut to length up to 20 2x4’s per minute and up to 45 boards per minute. It is available in either three phase or single phase. For more information call 314-202-1039 or email firstname.lastname@example.org.